This is an advertisementInterested In Advertising? | Contact Us Here
i did that, its been sent back now...didnt increase production at all.
Right, a lot of you on here will have read and re-read my various trials and tribulations of my merlin system, and TDS issues, but I will add a quick brief to bring you up to speed, just before I sling it out the window and reverse over it a few times...ok, so, to get you up to speed:Source: 335After RO: 79After DI: 18So, took advise on here and from a supplier, ordered new filter and membranes for merlin.Fitted, ran system, resulting in TDS after RO @ 60-65.Spoke to supplier, who advised me it could be my water pressure, as i was running standard garden hose to garage, then through system.Moved system to outdoor tap, which runs just under 30psi.Ran system for hours, and still resulted in TDS after RO @ 60-65.Ended up taking the system up to Steve CM, who kindly ran the system up to see if it was a pressure issue, it made no difference at his place, still ran @ 65 TDS.Spoke to supplier again, who advised pressure may be too low, and to run system off washing machine outlet in the house, as the pressure is around 40psi.They kindly sent me some fixings for the tap, and the original pipework, to give me the best possible chance of building pressure up.Hooked it all up to the 40psi tap this morning, been running it around half an hour now, and still coming out at TDS of 60+/-.I really am about to give up here, as this is just getting beyond a joke.I have been told that 40psi is enough to get the membranes operating effectively, but it appears not.I have spent a lot of time and money on this system, and can't afford to replace it just yet, however, it appears I am at a loss with it if my water pressure isn't sufficient to get the TDS down.A question...would a 4040 be ok off a 30psi outdoor tap?