This is an advertisement
Interested In Advertising? | Contact Us Here

Warning!

 

Welcome to Clean It Up; the UK`s largest cleaning forum with over 34,000 members

 

Please login or register to post and reply to topics.      

 

Forgot your password? Click here

Rayleigh Window Cleaning Services

  • Posts: 332
Help please
« on: February 11, 2008, 11:12:27 pm »
Having purchased a digital varistream and installed in van I have  problem.

 It does not shut off when flow is stopped, causing build up pressure.

I have looked back at past posts and someone mentioned adjusting the shut off setting which has to be done as different size hoses are being used by users.

I did not receive any instructions with this controller.

Any ideas

 

john tomkins

  • Posts: 1639
Re: Help please
« Reply #1 on: February 11, 2008, 11:34:31 pm »
I ain't got one but I'm sure I read you hold down the  "+" & "-" buttons to adjust the pressure setting.
Hopefully someone with one will confirm.

stevedale

  • Posts: 34
Re: Help please
« Reply #2 on: February 12, 2008, 07:58:01 am »
you might not get this im banned..........   
           hold up and down buttons together for 3 seconds , release for 2 seconds then hold again, this gives you the preasure setting, adjust this ...... mine is set on 9 with the flow rate on 3 or 4 , with 8mm hose .....
          steve

TVCS

  • Posts: 884
Re: Help please
« Reply #3 on: February 12, 2008, 08:34:14 am »
i tried to adjust mine and all I found was the settings A to E  So I'm confused.
....mine is set on 9 with the flow rate on 3 or 4 , with 8mm hose .....

The flow rate is pretty poor on mine.  It is factory set on C  and any higher than 1 or 2 the pump stops and starts and the flow at the end of the pole goes upand down too.  Most annoying.
Veni, vidi, vino, splatus.

 (I came, I saw, I drank, I fell over...)