[billygoat]

Has anyone found where you can get these,because I've searched and found nothing like it anywhere

It's a Gaz swivel Mk1  if you didn't know.

Tim
 

[jouk45]

billygoat, try 2 part epoxy clear resin, from B&Q. 4 minute seting, its realy strong,
you would have to dismantle the screws from the brush, and then remove the little swivel bar
then repair,

http://www.toolspot.co.uk/product/2pc-epoxy-adhesive-in-tubes-carded-multiples-24-only

[billygoat]

Thanks jouk,I'll give it a go.

[D.Salkeld_Ltd]

Jouk,

NOW you tell me......................I binned mine :

David

[jouk45]

Jouk,

NOW you tell me......................I binned mine :

David

oops sory david, fist time i have heard this question  : just noticed something on your brush pic billygoat,
where the black screw is, at the sides, we have them but they have 2 screws in each side, this stops the movment up and down,  gaz Hh20 set them at a 45d angle, this way it only swivels left to right, and i think
it was basicly to help stop them breaking,

[JM123]

gaz will still supply the mk1 swivel adapter.

give him a ring.