[joe.b]

hey everyone, i pressure washed a block paving job the other day and resanded it today and there was a little moss left in the cracks, is there any way of getting rid of this without pressure washing again?

thanks

[Ged]

for the odd bit i just use a wire brush. by the way did you clean with a flat surface cleaner or lance or both,

Ged

[joe.b]

both, very messy job 

[Ged]

i usually go over the whole area  lightly with turbo at end of clean to pick up the bits not rmoved with fsc and to get rid of stubborn weeds. saves  time and agro when you return to resand and find some moss is still there cos when it was wet you didn't notice it  and then some more and then...etc.

ged