[macmac]

got a new vikan with 3mm jets in (thats how it came) but i want to replace them with 2mm ones. can i do a direct swap or will the holes drilled in the brush for the 3mm ones be too big?

any advise welcomed

tony

[Chris Cottrell]

Hard to reply really depends on whos jets they are

Chris

[john tomkins]

If they are brass just solder the ends up and redrill them at 2mm

[chris@c.m.s]

My first pole came with a Vikan brush supplied by Gardiners that had 3mm jets they had run out of 2mm I think, they sent replacements as soon as they had new stock in and I dont remember any problems swapping them over.   

[macmac]

thanks guys
the brush came from wintecs & the jets are brass.

tony

[Alex Gardiner]

The jets in your brush will be too big to just swap over to our 2mm jets, but what you can do is drill a new 4.8mm hole next to the old holes and push-fit the new jets in.