[dave_carroll]

had my kit a couple of weeks and its great BUT.....
 came home today and needed to make water, my reading started at 35ppm dropped quickly to 29ppm is now down to 22ppm after an hour but seems to be stuck there.
   do i just leave it running hoping that it will drop or is there anything that can be done.
help i dont want to use my ladders

       swamps

[Ian_Giles]

Swamps,
Which reading is it, the 'in' one or the out one?

I think, if I remember other postings that you have Peter's System, the same as myself.
If you have fiddled with the probes (as I did) you must make sure that the 2 tiny dots, 1 on the probe and 1 on the mounting are perfectly aligned. Peter told me that you can also get something he called 'TDS creep' giving a false reading.
Mine settled down fine.
A further check would be to also have a hand held meter.
Did you have the hard or soft water setup? Mine was the hard water setup, therefore I had the RO membranes and the DI resin too.
If yours is the same, what is your 'in' reading and your 'out' reading too?
You can always ring Peter or mail him and he can explain things fully then.

Ian

[dave_carroll]

ian,  
    was the out, managed to get enough for today tds 8
but got back and my out is higher than my in   just checked the dots, didn't make any difference, i've just swapped them over out-in in-out, and the red in probe still says lower than the blue out probe so maybe its the meter thats gone a bo  .
 swamps

[Ian_Giles]

methinks that is impossible! therefore you have a bit of a glitch there somewhere.
Give Peter a ring, he will advise you.

Ian

[dave_carroll]

ian,
     e-mailed him yesterday, he did reply last night, but i was a tired little puppy and went to bed so i've only just read e-mail, he seems to think the same.
       swamps

[dave_carroll]

All,
    hows that for service, no sooner had i posted when peter phones me up, he's sorting me out.
                    swamps