[Clear Vision]

I just got one of gaz's brushes and a couple of cleantech's push fit fan jets.

How on earth do I fit them

What other fittings will I need?

What size of pipe will I need?

I am going to fit the brush to a 2.4m pole (2 section) What piping will I need?

Cheers

Matthew

[matt]

i did a guide to building a brush

its on the DIY site

http://www.d.co.uk/brush/

[Clear Vision]

Thanks matt. thats great

Where can I get the bulkhead connectors from?

Matthew

[chris@c.m.s]

Mathew what pole are you hoping to put your brush onto?
 

[matt]

Thanks matt. thats great

Where can I get the bulkhead connectors from?

Matthew

cleantech, only a few quid

[JM123]

esiest way is to drill 2 8mm holes and push them through with the hose on them from the bristle side  - nice tight fit and takes 2 mins

[s.hughes]

I dont think that jet needs a bulkhead connector. I could be wrong but cleantech do 2 types of them jets and one needs them the other dont

steve

[matt]

I dont think that jet needs a bulkhead connector. I could be wrong but cleantech do 2 types of them jets and one needs them the other dont

steve

the jet is in the pic next to the brush, and its the type that needs the bulkhead connection

[JM123]

here's how its done - NO bulkhead required.

sorry for the poor picture quality but I had to use the phone to take the pics

[Jeff Brimble]

You got woodworm in that brush too 

[JM123]

No actually its ventilation holes as I work so fast I need to ventilate the brush to stop it overheating.

[Jeff Brimble]

That will be a new topic then
 "Help what removes friction burns off glass ? "

[JM123]

 

gg4!!