[Pete Thompson]

I picked up some slick connect fittings at the show, put them on my poles and hoses today.

First impressions are really good, I like how easy they are to connect and disconnect.

BUT they seem a little delicate? Will they survive being dragged around on the ground?

[Spruce]

I picked up some slick connect fittings at the show, put them on my poles and hoses today.

First impressions are really good, I like how easy they are to connect and disconnect.

BUT they seem a little delicate? Will they survive being dragged around on the ground?

The ridges do wear  over time. I would say the first one on my pole hose lasted about a year. Funnily enough, the hose reel connector hasn't been changed and is still going.

[richard connett]

I’ve used them but I don’t think they are as durable as they should be for the price. I’ve gone over to  rooteks tuff connectors , now they are tough

[Scotty1]

I’ve used them but I don’t think they are as durable as they should be for the price. I’ve gone over to  rooteks tuff connectors , now they are tough

Same here

One thing I didn't like about the slick connect was grass getting stuck in the slits and then splaying out then catching on everything.  Plus they are easier to break and less streamlined than the tuff rookec or whatever they are called lol 😂

[Pete Thompson]

Thanks for the feedback. I used them for the first time today, and I really liked them! So easy to connect and disconnect (yes I know, that’s the whole point!).

A little bit scuffed from being dragged around, but only time will tell how long they last. I’m considering wrapping them radiator hose to protect them.

A more pressing concern is that if one were to break while I’m out working, the chances of me being able to get the pole hose over that barb (without a cup of boiling water to sit the end in first) are probably nil.

[Spruce]

Thanks for the feedback. I used them for the first time today, and I really liked them! So easy to connect and disconnect (yes I know, that’s the whole point!).

A little bit scuffed from being dragged around, but only time will tell how long they last. I’m considering wrapping them radiator hose to protect them.

A more pressing concern is that if one were to break while I’m out working, the chances of me being able to get the pole hose over that barb (without a cup of boiling water to sit the end in first) are probably nil.

I think it's the outer casing that would break first and would be because you stood on it which is easily done. It's this out casing or shell that will wear thin over time.

I do carry a couple of spare ones on the van. A cigarette lighter could be the best option to warm up plastic pipe if you are out and about.
I have used the hot air from my diesel heater's exhaust before.

I also purchased a few o rings but have never needed to replace one yet.