I have just bought a 10 amp charger, it arrived today(borrowed my father-in-laws ancient charger to get started).
Anyway I thought I better put battery on charge as I have used it 3 days straight.
Stuck it straight on fast charge & the blummin fuse blew immediately. Do you think battery didn't need charging & by me putting it straight on fast charge I have overloaded it. Puzzled
Hi Paul
Is it a lesiure charger?
I would never recommend a fast charge, the reason for this is causes to much heat in the battery and can buckle the plates, even if it doesn't it will reduce the life of your battery.
All batteries are manufactured to provide a certain number of deep discharge cycles.
The conventional leisure battery should give a cycling life of between 200-300 deep discharges.
A Gel battery will give between 400-500 cycles and an AGM battery 600-800 cycles.
There are manufacturers that sell leisure batteries that deep cycle up to and over 1000 deep discharge cycles
Batteries fail in cycling life due to a permanent encapsulation of PbS04 on the plates (lead sulphation)
The capacity loss is more rapid with these battery types, the deeper that the battery is discharged, the quicker lead sulphation builds up. Upon recharging the battery, not all of this sulphation is converted back to lead (PB0). The result is a gradual loss in capacity.
Another major reason for premature battery failure is due to the oxide shredding from the plates. Standard lead plates are bound only with acrylic and polyester fibres, they do not serve as reinforcement of the plate. The cycling life of the more expensive battery is much greater than all other battery types because they are built using carbon fibre and this eliminates lead sulphation of the plates permanently. Upon recharging all the original capacity will be replenished. Carbon fibre acts as a mechanical reinforcement fibre to the lead grid and paste reducing shredding.
But to answer your question, either the battery charger is faulty or the battery required more current on start up, or it could have been a initial surge on switch on this can cause a fuse to blow.