This is an advertisement
Interested In Advertising? | Contact Us Here

Warning!

 

Welcome to Clean It Up; the UK`s largest cleaning forum with over 34,000 members

 

Please login or register to post and reply to topics.      

 

Forgot your password? Click here

andyralph

  • Posts: 362
Fitting gate valves
« on: March 26, 2022, 12:34:54 pm »
Hi all my system as an automatic flush system fitted I’ve just posted about water production as I’m getting to much waste can I replace my gate valve with an adjustable valve so I can alter my water distribution ie more pure and less waist to suit thanks andy

Smudger

  • Posts: 13438
Re: Fitting gate valves
« Reply #1 on: March 26, 2022, 01:05:00 pm »
Yes you can - it shouldn't matter to the system unless of course to close it completely

I love the pre drilled hole system - I found mine had worn badly after several years - I brought a new one from a plumbers shop and drilled a new hole through it - I have 2 now with differing size holes which I can change over to get better production in the summer or winter

Darran
Never argue with an idiot, they will only bring you down to their level, and beat you with experience

andyralph

  • Posts: 362
Re: Fitting gate valves
« Reply #2 on: March 26, 2022, 01:26:45 pm »
Hi Darren what size hole do use for summer and what size for winter take it smaller hole for winter thanks andy

Mike Burd

Re: Fitting gate valves
« Reply #3 on: March 26, 2022, 03:28:15 pm »
Yes you can - it shouldn't matter to the system unless of course to close it completely

I love the pre drilled hole system - I found mine had worn badly after several years - I brought a new one from a plumbers shop and drilled a new hole through it - I have 2 now with differing size holes which I can change over to get better production in the summer or winter

Darran
On a Pure Freedom system less than a year old, production dropped to a trickle but changing the gate valve sorted it. In the meantime I’d bought a new membrane and a new pump.  ::)roll

Smudger

  • Posts: 13438
Re: Fitting gate valves
« Reply #4 on: March 27, 2022, 03:36:24 pm »
I use a 2.6mm hole spring summer autumn and 2.2mm hole  in winter ( however this year was mild and production speed, waste ratio and TDS remained the same

Just be careful using a too smaller hole can give you really good results in terms of production speed and TDS short term but may bu@@er up the membrane long term (shorten its effective life ) - the above work best with by system - last membrane has been running a year at 130 Ltrs of pure p/h at 0.006 (from 320)

Darran
Never argue with an idiot, they will only bring you down to their level, and beat you with experience

Re: Fitting gate valves
« Reply #5 on: March 28, 2022, 09:04:23 pm »
Alternatively a gate valve without a hole drilled in it. T section before and after with a "bypass". Fit a simple on/off tap to the bypass for production/flush and set the gate valve to desired ratio. This means you can tweak the ratio whenever you like depending on the season and water temp.