[Plankton]

I've used some temporary bits for now.
Setup; https://youtu.be/gO4pu1lNmjo
In use; https://youtu.be/_iYJk-WZyo4
After a light pressure clean to remove the grass between the joints; https://youtu.be/_iYJk-WZyo4

[Smurf]

Nice one Alan...
Think you meant to put this link up for the last one though.
https://www.youtube.com/watch?v=gUVw2Jo-DUM

[Plankton]

Nice one Alan...
Think you meant to put this link up for the last one though.
https://www.youtube.com/watch?v=gUVw2Jo-DUM

Notice how it ends in DUM!
I want to have 10mm id hose running from the ball valve to the spray head or as close to it before it reduces down to the 8mm inlet on the "Dualtool Water Fed Pole Nozzle Adaptor"
Or I could use a couple of these instead; https://www.softwashtechnology.co.uk/collections/lances-and-jets/products/benz-spray-nozzle-push-fit-type which come with a 10mm barb.
Problem with the barb is that the hose will be fixed to it and you need to change between nozzles? In any case I've ordered a 10mm to 6mm reducer to use with the 8mm id push fit.