[Dazzler3370]

Hi all I've just changed over to Microbore, however i have to have my controller on full just for a standard 2 jet brush. I have tried my 4 jet brush and water just trickles out.
I like the fact that its a lighter weight and easier to use.
How can I get more pressure through it. Do I need a more powerful pump/LPM currently using 100psi

Cheers
Dazzler

[matthewprice]

At one time I used microbore and only had to up the controller a bit .If I remember 60 up to 70 .Seemed to work ok .Just about to go back to microbore again .So hope to test over weekend

[Tosh]

Are you using 6mm bore hose?

How many litres a minute is your pump intended to produce?

[Don Kee]

Recalibrate your controller

[mark coates]

Your controller actually has 2 settings, 1 for the water flow rate, which is the number we usually see displayed, and a second setting to decide at what pressure setting your pump should switch off. You may need to up this second setting.