Interested In Advertising? | Contact Us Here
Warning!

 

Welcome to Clean It Up; the UK`s largest cleaning forum with over 34,000 members

 

Please login or register to post and reply to topics.      

 

Forgot your password? Click here

kevincoggan

  • Posts: 97
webasto question
« on: August 29, 2016, 07:15:43 pm »
does anyone know the voltage draw on start up on a 9kw unit?,i'm about to choose a split charge relay but need to choose one which suits the webasto(if you have one you'll know what i mean)tia

robert mitchell

  • Posts: 1997
Re: webasto question
« Reply #1 on: August 29, 2016, 07:45:11 pm »
does anyone know the voltage draw on start up on a 9kw unit?,i'm about to choose a split charge relay but need to choose one which suits the webasto(if you have one you'll know what i mean)tia

Surely the start up power is irrelevent , your battery will only take a charge at a certain rate , depending on battery .
www.ishinewindowcleaning.co.uk

The man who never made a mistake never made anything.

Spruce

  • Posts: 8465
Re: webasto question
« Reply #2 on: August 29, 2016, 10:01:48 pm »
does anyone know the voltage draw on start up on a 9kw unit?,i'm about to choose a split charge relay but need to choose one which suits the webasto(if you have one you'll know what i mean)tia

Surely the start up power is irrelevent , your battery will only take a charge at a certain rate , depending on battery .

True, but the likes of Ionic usually provide a separate leisure battery (around 110 amph) for their diesel heaters.

I don't know the exact answer to your question, but my Eberspatcher Airtronic draws spikes of up to 18 amps on startup, but it not continuous. Its also over a short period of time. Once its fired up it draws about 2.5 amps on full throttle and about 1.8 amps on reduced mode. I recon overall it probably draws around the same current as a single Shurflo pump.

I think the problem with hydronic  diesel heaters in our industry is the stop start they they have to deal with. So over a relatively short period of time a 110 amp leisure battery could be flat if not supplementary charged.

My advice is to get a heavy duty VSR. The one I have on my van is similar to the 140 amp Durite model with 75 amp cables. I've seen my alternator push 20 amps into my 110 amph leisure battery after a heavy day but with a few minutes it drops to about 10/11 amps and then drops further to around 7/8 amps.

As I've said before, we do very little mileage so I charge my leisure battery every 2nd night in summer and every night in winter. I plug the charger in at the same time I put the heater on.

-
Success is 1% inspiration, 98% perspiration and 2% attention to detail!

The older I get, the better I was ;)

Oliver @ GrippaTank

  • Posts: 356
Re: webasto question
« Reply #3 on: August 30, 2016, 09:59:50 am »
Good Morning,

The information provided by Spruce for the Eberspacher is pretty similar to the Webasto units.

The Webasto units can peak upto 17 amps on startup, and then will run between 2 - 7 amps when running - as Spruce says, similar to a 100psi water pump depending on the flow rate.

 Our recommendations would be as follows:

2 x 100ah (minimum) batteries

A charging system such as:

https://www.grippatank.co.uk/12v-24v-intelligent-split-charge-relay-100amp

or if its a vehicle registered 2016 onwards:

https://www.grippatank.co.uk/full-kit-12v-30amp-smart-battery-to-battery-charger

We hope this helps - do contact us directly if you need any more help.

www.grippatank.co.uk - The home of the GrippaMAX crash tested cleaning system. Contact us on 0800 098 8407 or enquiries@grippatank.co.uk