[Paul H Coulthard]

Hi all  going to be buying  2 X new vacum motors for my enforcer machine this week I normally just ring ashbys to buy partsfor my machine does any were else sell them in my machine there is a standard vacum and a hd vacum. Is there anything more powerfull than these vacum motors that will fit straight in to my enforcer without changing things around. Thanks paul 

[john martin]

Hi all  going to be buying  2 X new vacum motors for my enforcer machine this week I normally just ring ashbys to buy partsfor my machine does any were else sell them in my machine there is a standard vacum and a hd vacum. Is there anything more powerfull than these vacum motors that will fit straight in to my enforcer without changing things around. Thanks paul

You can get the 'ashbys ' electro motors from restormate or alltec or others  .  The more powerfull 'HD' one is an electro 6600-49
so make sure u get the 49 at the end .
More power ?   its being covered on other enforcer threads but easiest is to fit two of the  49 ( 1500w) vacs insted of the lower powered one .   
There are two slightly more powerfull electro 5.7s but you would have to import them . One of them wont work anyway in a one cord machine as its about 8.5amps.
I put the 6.6 in mine at the moment , mainly becaure there cheap at as little as 99 from places like woodbridge . They do work well in series though .
You have to make little extension brackets though to fit ...  like in the pic here



does anyone get a ban message now and then    it only shows on one of my devices  ....  goes away after restarting i think

Sorry john martin, you are banned from using this forum!
Same as before. Banned again. Take your views elsewhere.
This ban is not set to expire.

[Paul H Coulthard]

Thank you john could I fit 2 X 6.6 motors in to my machine ? And would they fit straight in thank you

[CleanerCarpets]

Haven't you only just replaced them?

[Paul H Coulthard]

Yea replaced them over Christmas mate. Not going to replace them right away just when there ready for it. 

[john martin]

Thank you john could I fit 2 X 6.6 motors in to my machine ? And would they fit straight in thank you

no     look at the picture , the 3 inch or so metal strips coming off the side of the motor , you need to cut those to bridge the gap between the mounting bolt and the motor mounting hole .
you get straight metal strips in many hardware places , just cut to size and drill a hole in them to attach . So  its not difficult as such , just not a straight swap .