[concept]

Been asked to quote a clean of a brick building, and was wondering if there was any recommended methods.

We've cleaned plenty of walls, cladding, fascias etc over the years, however, a full building worries me a little.

Have used pressure washers with no chemicals or heat previously and walls have come up fine, just worried about the pointing, and quality of finish. as its a fairly high profile building, and we get a lot of work from these clients.

[Rob_Mac]

I would look at a low level section and if the mortar is sound then take a general thinking that the rest of it is in a similar state.

I've got a brick clean amongst other cleaning, starting on Monday and I have no concerns about blowing the mortar out.

I will be using turbo nozzles.

Unless the brick faces are blown and the mortar is loose , my experience is that it wont damage, just don't spend too long on one particular section.

Good luck

Rob

[concept]

Cheers Rob, looked at a few of your videos on YouTube as well.

[Rob_Mac]

That must be Lee because I don't have any on their yet. There will be some popping up in the very near future.

Rob

[concept]

You Northerners all look the same!! 

[Rob_Mac]

Above Warrington



Where I live



Everywhere below where I live



Rob

[Aqua Power Solutions]

And the people in Scotland  

[Rob_Mac]

This makes me think of someone,

It isn't boring on here

Rob