Tosh.
Can I ask how your pump is wire to your battery and controller.
You have a shurflo pump a voltage regulator as displayed by Ian.
So red and black wire on pump as I have but you have the additional wire/wires on pressure switch how do these wire into your controller and battery?
Are you taking wire from pressure switch and joining to other say red wire at other end of pump then wire to controller?
Just trying to invision this, can't find anything on YouTube all in use with varistream.
My pump has no wiring on pressure switch but would like to setup as yours Tosh.
Thanks lee
Lee, you have two wires coming out of your shurflo; route one of these (it doesn't matter which) into the pressure switch (it doesn't matter which connection) with a spade connection. Then attach a wire with a spade connection on the 'way out' (the other connection on the pressure switch).
This is your pressure switch connected back up. All the pressure switch does is break the connection when the pressure has built up to the required psi.
Then wire as follows on the rear of the motor controller:
On the reverse side of the motor controller are some screws that hold down the wires; it's pretty self explanatory.
Keep your old pump controller box; you can just use that to put it in.
And as I say, it works all the time, every time, no exceptions.
(The above is my spare - at a fiver each - get a couple, but my two have been going great guns for over six months - with no problems at all).