[windiewasher]

Hello anybody know why one of my pure freedom trolleys not pumping water?
as soon as it runs out of water,i put new bottle on and it doesn't pump through,my other is fine but that doesn't have a shurflo pump,
Is there anything I can do or shall I change pump?
Cheers

[stig]

Hello anybody know why one of my pure freedom trolleys not pumping water?
as soon as it runs out of water,i put new bottle on and it doesn't pump through,my other is fine but that doesn't have a shurflo pump,
Is there anything I can do or shall I change pump?
Cheers

shove a finger in hole while switched to max.....

[windiewasher]

Hello anybody know why one of my pure freedom trolleys not pumping water?
as soon as it runs out of water,i put new bottle on and it doesn't pump through,my other is fine but that doesn't have a shurflo pump,
Is there anything I can do or shall I change pump?
Cheers

shove a finger in hole while switched to max.....

Which hole mate?

[Mike #1]

Turn the pump on full tilt should sort it out .

Then never let the containers run dry always switch when their is a few inches left in the bottom . Mike

[stig]

Put on a new barrel,disconnect hose ,turn onto full power then put finger in where hose goes ....let air out mate.

[crystal.clear]

Turn the pump on and then lay the pole on the ground till it starts working.

[shina]

put on new barrel. switch on controller and disconnect hose run for 2 secs on full then reconnect hose.

[stig]

put on new barrel. switch on controller and disconnect hose run for 2 secs on full then reconnect hose.

......but if the guy has run it dry ain't it advisable to put finger in hose connector to pump air lock out!

[Frankybadboy]

put a non return value on the end and job sorted no air locks


perfreedom sell um

[stig]

But if you run a barrel dry then when you put a fresh un on you need to get air out by switching on and sticking a finger in to bleed out the air. 

[shina]

But if you run a barrel dry then when you put a fresh un on you need to get air out by switching on and sticking a finger in to bleed out the air. 

No. If you disconnect the hose from the pump and run on high power for a few seconds then that does the job. You will see the the water sputtering and then flow fast.
I have a non-return valve and I have to do this on each barrel change. I never run dry but still have to do this.