[Joe W Brown]

One jet is not letting anything out at all and the other dosnt seem to be letting enough out. At 300psi it is just dampening the surface.

Any ideas?

Thanks

[Carpet Dawg]

what tool you got?

maybe something blocking the holes? use a bit of fuse wire to unblock. best to take of the jet off before doing that to make sure you dont push it further in.

[Simon@arenaclean]

When you remove the Jets there may be a filter with a check valve, these just pull out but they may need a gentle twist with flat screwdriver. Give these a good rinse under the tap and use a worn tooth brush as they can get blocked. Inside the mesh is a small bearing and a spring and they need the flow of water through them to work.

[AshWhite]

When you remove the Jets there may be a filter with a check valve, these just pull out but they may need a gentle twist with flat screwdriver. Give these a good rinse under the tap and use a worn your Mrs' tooth brush as they can get blocked. Inside the mesh is a small bearing and a spring and they need the flow of water through them to work.

Fixed