[paul marshall]

fitted a john guest tap to my facelift pole hose , fitted at top by brush , now i tryed to fit it on difrent brush which has yellow 5 inch hose but it wont quite fit in , ive warmed it up with hot water but to no avail , i have only seen a 8 inch tap to but on line , my tap now says 5 and a half on it what ever that means .. hope this makes sence 

[matthewprice]

did you say 5 inch hose bloody h,,,ll you must a fireman

[paul marshall]

 

[paul marshall]

sorry you got me there 5mm

[paul marshall]

got all my facts now , the pole hose is lite -5 and i need a john guest tap to fot it 

[pure tech]

I use a JG 1/4" push fit tap at the brush head. I cut the pole hose just before the Y and then superglue in a bit of 1/4" RO tubing at each and the JG fits nicely.

[Alex Gardiner]

got all my facts now , the pole hose is lite -5 and i need a john guest tap to fot it 

What you need is the following:

1x 8mm Push-Fit inline valve:


2x 6mm barb to 8mm JG stem to fit one in either end:

[paul marshall]

thank you alex , just gone to website to order and noticed you had some much cheaper plastic taps , maybe not as good quality but im always breaking stuff anyway so would go with cheaper option , would any of these do me , thanx in advance 

[Alex Gardiner]

thank you alex , just gone to website to order and noticed you had some much cheaper plastic taps , maybe not as good quality but im always breaking stuff anyway so would go with cheaper option , would any of these do me , thanx in advance 

These plastic taps would not fit this size hose and are more for isolation purposes (tanks, etc) so are not as easy to operate.

[paul marshall]

thanx alex just ordered them of your website , im hopeless with fittings and sizes ,