[New Guy]

I have a brush with two jets in the head and these only fire out two narrow water jets.
Can i change the holes in my brush head to Jets that Spray the water over a larger area???

[matt]

what brush have you got ?? ?? ? ?

and do the jets sit in holders ?? ?? ? ?

[New Guy]

i have a brodex pole and the head came with it
the jets are a hexagon nut  with 1mm hole in middle solid cast jet sunk into the brush.

[New Guy]

loks like a vikan 
red and green

[matt]

i would get in touch with Brodex, afterall thats why you pay your money, for a bit of aftersales care

if it has holders and its the same size, then i know cleantech do some nice spray jets

[Pole2pole]

I gotta vikan.....same kinda problem. Unless i'm pumping water out for England,it's hard to rinse from top left and right corners  Can anyone advise how to remove jets and once again, point me in the right direction(cleantech again???) 

[JM123]

I've found the brass jets need to be pushed out backwards - why oh why do they fit them??? - anyway - if you're really stuck you can drill them out and use the nozzles from cleantech as they're bigger with a fan thingy on them and oh yeah they're a lot better, plus save loads of time rinsing.  Think they cost bout £4 each all in.

[genesis_windows]

i use same vikan brushes and have sourced some lovely jets from those dudes at cleantech! i make them up myself and they spray across the whole length of the brush and dont use loads of water. being made from stainless they dont snap in the cold or when dropped and will probably outlast the brush.they cost about 99p each.

[Pole2pole]

cheers gang..I'm off shopping AGAIN 

[kingfisher]

Anyone got a link for Cleantec

Thanks Kev

[DODA]

www.cleantech.co.uk

try that .......

[matt]

dont forget the holders they go in though

think they call them "bulkhead connectors"

[Pole2pole]

I can't see 'em on cleantech peeps  Am i just not looking hard enough or something???

[Ben Walker]

maybe its this:

http://www.cleantech.co.uk/product_info.php?cPath=25_48_90&products_id=614

cant see 'bulkhead connectors' (matts post) though

ben

[matt]

give them a bell to ask

[matt]

if you hang on till tomorrow night

i am building a brush tomorrow night

i will get a bit of a guide up on the DIY forum

how to build a brush head

ive worked out a bit of a knack at it now, i ruined 2 brush heads in learning but hey, its all part of the fun

[s.hughes]

If you cant find what your looking for on cleantec website then just give them a call on 08451305006. They are real helpful

Steve

[Peter Fogwill]

If you cant find what your looking for on cleantec website then just give them a call on 08451305006. They are real helpful

Steve

What you want to ask for is two 6mm bulkhead connectors and two jets.  The bulkhead connectors are 6mm push-fits, so unless you have the 6mm pipe you would also need to get some pipe and a t' connector to join the two pieces of pipe together.  Then you need an adapter that will go from the 6mm T to what ever pipe size supplies your brush.  All you have to do then is drill two holes in your brush a mm smaller than the outside diameter of your bulkhead connectors, and screw them in.  Connect up your bulkheads with your T using the 6mm pipe, fit the adapter and that's it, a brush with fan sprays.

Peter Fogwill
www.window-tools.com