[APWS]

my 18" whirl-a-way rotary has lost most of it's pressure, i have checked the nozzels they are ok, there are no leaks as i can tell,  the rotary arm seems fine, & there is plenty of grease in the rotary, i used it yesterday on some imprinted concrete and it was leaving circles the arm only seemed to be going round at half speed,
anyone got any idea's?
regards,
jim.

[jaespray]

hi jim   if your nozzels realy are clear try running it with out nozzels fitted
i once had a little "0" ring stuck in one of the arms
god only knows where that came from
regards john

[BDCS]

If you can see nothing wrong with the fsc whats the pressure washer like with the gun on ? I had similar with mine which in the end turned out to be one of the valves not seating

[APWS]

If you can see nothing wrong with the fsc whats the pressure washer like with the gun on ? I had similar with mine which in the end turned out to be one of the valves not seating

the lance works fine on the pw and my other rotary is ok on both machines, i have had the whirl-a-way for three years now & not one once of trouble till now,
i will try what you say john, thanks,
jim.

[jaespray]

hi jim    good luck
regards john

[clarkson]

 hi
 i had this recently and the seals had gone.

 cheers

 john

[drive surgeon]

check that no water is coming out the little hole on the bearing drum wen the handle is pressed. if it is then the viton o ring has gone!  its a bit of a pain putting a new one on but worth doing for future reference.

[APWS]

thanks guys, i got a day off this sunday first time in over three weeks i will have a good look at it then,
jim.