This is an advertisementInterested In Advertising? | Contact Us Here
i asked gardners today while pre ordering a 22ft slx about doing this as i need something slightly longer for a couple of jobs, she said i could get a section from the slx 25 and use that but would have to take the clamp bolt and lever off every time i want to add it to the 22ft one and the same when taking it off.
Quote from: p1w1 on June 14, 2011, 09:45:57 pmi asked gardners today while pre ordering a 22ft slx about doing this as i need something slightly longer for a couple of jobs, she said i could get a section from the slx 25 and use that but would have to take the clamp bolt and lever off every time i want to add it to the 22ft one and the same when taking it off.Also arent you ment to use the appropriate base section too? I.E. if you want to upgrade your pole 1 section you have to buy 2, well dont have to but Im sure its reccomended.
Could I suggest that over say 25-30ft a modular should be used ?
why would you have to remove the clamp and lever bolt?
Quote from: p1w1 on June 14, 2011, 09:45:57 pmi asked gardners today while pre ordering a 22ft slx about doing this as i need something slightly longer for a couple of jobs, she said i could get a section from the slx 25 and use that but would have to take the clamp bolt and lever off every time i want to add it to the 22ft one and the same when taking it off.If adding an extra section to the handle section of an SL-X you will not need to take off the lever each time. All you will need to do is to remove the end cap from your current handle section and slide the new handle section on. If you were to buy a larger pole and remove sections when not needed, you would then need to remove the lever in order to open the clamps up to slide over the joint stop tape (unless you remove this tape).
Quote from: Alex Gardiner on June 15, 2011, 07:42:42 amQuote from: p1w1 on June 14, 2011, 09:45:57 pmi asked gardners today while pre ordering a 22ft slx about doing this as i need something slightly longer for a couple of jobs, she said i could get a section from the slx 25 and use that but would have to take the clamp bolt and lever off every time i want to add it to the 22ft one and the same when taking it off.If adding an extra section to the handle section of an SL-X you will not need to take off the lever each time. All you will need to do is to remove the end cap from your current handle section and slide the new handle section on. If you were to buy a larger pole and remove sections when not needed, you would then need to remove the lever in order to open the clamps up to slide over the joint stop tape (unless you remove this tape).HiCan I just buy an extra section then that will fit the base section of the slx 22 from yourselves that I Can add when needed Thanks