so how much scrubbing and rinsing do you all do?
ive seen some right cowboys, must be leaving spots everywhere!
ive recently started scrubbing and rinsing more ever since ive noticed quite a few of the windows i do have spots on them
new method...
1) i have now turned up my water flow one notch for better rinsing, downside i use more water!
im double di only using a 35lt trolley, with tap water tds of 300ppm but i only use wfp for anything above ground floor
2) i now scrub the frames longer and rinse the the top edge of the frame for a couple of seconds to avoid drips!
3) i used to only scrub the glass once then a really quick little rinse with hardly any water presure
(i think this is what cuased the spotting in the first place as well as a lack of scrubbing)
so now i scrub the glass twice and more on the tope sides and bottom where there prone to
spotting in my experience.
4) rinsing, i now rinse with more water presure and start at the top of the glass and slowly from side to side and downwards rinse the glass all the way to the bottom.
5) finally i brush the sill backwards and forwards 2 or 3 times
ok if your still reading, thanks
i know im going into detail but i feel its necessary, because i dont wont to start losing custys cos of the spots
or even worse have to replace hard water stained glass
ive checked some of these spots and they wont come off
there defo water marks that need some work to get off
they dont even come off using trad ive tried
now my new method takes a bit longer but what are all your methods?
thanks
GB