[Paul H]

been asked by a friend (builder) regarding the removal of this.......any advice re products technique ...cost...welcome so i can advise him,

thanks

[Griffus]

If small volumes then we use an industrial paint stripper (nitromors equivalent).

[Paul H]

dont think its small.....sounds like some has crossed someone....and had paint chucked all over the door....door had been replaced....unlike the surrounding brickwork and path!

[Roger Oakley]

Cleaned one like this before, hot pressure wash and ezee strip from Tensid worked for me.

[Andy Foster]

Does it look something like this?



Used steam and ghost remover and ended up like this.

[drive surgeon]

how long did it take you andy?  i have a job like this to do this week. i need to get some chemicals, so it needs to be steam then? not just hot water? low pressure steam?

[drive surgeon]

also can the stripper be used on the glass window as there is paint on glass window aswell?

[Andy Foster]

For paint on glass use a glass scraper, its easier.

If I remember rightly this job took about 2 hours from starting to set up, to pulling away at the end of the job.  It also included another wall and the floor in the porch... also the concrete slab pathway leading to the house.

It was the hottest day of the year and in that porch I was enveloped in steam... nice!!!!

[drive surgeon]

ok andy thanks. i found this wen searching older posts as i have an identical job by me!