Hi guys,
Steve has been very helpful with us all , and has put into practice a cheaper hot water solution , to get us going again in this freezing weather
Well done Steve!
I am following up with this thread as Steve has locked his topic now, which is fine as there are too many questions on there for him,
But i just wondered if anyone can help further,
i am putting one horizontal in the bottom of my 640 ibc, but .....
How do i seal the inside , without an arm extention?
where do we buy the mechanical flange, ?..........and any ideas on screwing together, when i am working from the tank lid opening.....to secure it to the tank, as well as sealant,?
Thanks again.