Interested In Advertising? | Contact Us Here
Warning!

 

Welcome to Clean It Up; the UK`s largest cleaning forum with over 34,000 members

 

Please login or register to post and reply to topics.      

 

Forgot your password? Click here

the red carpet

  • Posts: 1162
WOODBRIDGE TM, RE DUMPING
« on: April 09, 2007, 08:21:55 pm »
As a few of you will know i have one of the Woodbridge tm's its the 25 model

I have had my fair share of problems with this machine, but have just got to the bottom of one of the main ones.

Now im pretty sure that the water dumping isnt quite right, i have been made to belive that the whole principal of these machines is that you set the temperature and when the water reaches that temp it dumps some water and some new water comes in thus lowering the temperature.

The machine then heats the water back up to the same temperature, and keeps repeating this cycle so the machine stays running at a even water temp (sounds good)



With mine,

If i set it to a low temperature (under 70) the machine constantly dumps water the whole time, so if im dumping into the waste i run out of water in no time and if i dump back to the clean tank that gets hotter and hotter and eventually cuts out ???

If i set it between (80-90) it works fine, it reaches temperature and then dumps a bit and then starts heating again.

If i set it any higher than 90 it reaches temperature and then stalls and cuts out ???

So i have a adjustable temperature dial, that can only be set at one temperature or the machine will cut out.

Chris R

  • Posts: 813
Re: WOODBRIDGE TM, RE DUMPING
« Reply #1 on: April 10, 2007, 12:04:36 am »
I leave my woodbridge on full temp all of the time.

when cleaning upholstery I use a CFR hand tool.

Using an 01 size jet keeps the water temp down when needed.

Most times I use an 02 size jet.

no problems with heat.

If it cuts out when dumping at high temps something is wrong ?

Sorry you are having all of these problems with your machine Red.

I have not heard of anyone else having similar problems ?

regards

Chris
Staffordshire

Mark Lane-Matthews

  • Posts: 303
Re: WOODBRIDGE TM, RE DUMPING
« Reply #2 on: April 10, 2007, 08:49:58 am »
Hi  Red
Give me a ring,07802 448871, i have had a similar problem to you and have found a solution.

                                                                Mark