[Carl@Cwc]

It will work, but I wouldn't describe it as good.

You will get the water coming out of the boiler at a maximum of 50deg.

So this will mean 30deg at the brush head

what doesnt work m8 ? probably me being an idiot.

8l boiler, 1 pump , 1 controller?

why would it only come out at 50 degrees?

my fogwash is connected the same way ,> fogwash>1 pump> 1 controller  and i can get it boiling hot

does each of your boilers have seperate controllers & pumps

[Alex Wingrove]

Because you are running two users from one pump the flow rate will inscrease. Because there is a increase in flow the water wont be as hot.

On the 10l boiler that I had because it was 15% larger than yours the water still could come out very hot.

But it was difficult to configure because when one user stopped his flow the flow rate would slow and the water would boil inside the boiler

[ptwt]

Alex do you have vents in your van floor?

[telfordwindowclnr]

I must say Alex, I really don't think you have a clue and have acted rashly, without thought, planning of the job at hand or consideration to your workforce. How very dare you...

[telfordwindowclnr]

P.S. I'm always here to help!

[Alex Wingrove]

Alex do you have vents in your van floor?

Nope

[Alex Wingrove]

I must say Alex, I really don't think you have a clue and have acted rashly, without thought, planning of the job at hand or consideration to your workforce. How very dare you...

Shut it Muppet.......

Only you are allowed to be chastised not me.

I have been thinking about the possibility of 4-6 users from a single boiler, with a proper water supply

[telfordwindowclnr]

I must say Alex, I really don't think you have a clue and have acted rashly, without thought, planning of the job at hand or consideration to your workforce. How very dare you...

Shut it Muppet.......

Only you are allowed to be chastised not me.

I have been thinking about the possibility of 4-6 users from a single boiler, with a proper water supply