[david knowles]

I have fitted a new pump to my Prochem cheyenne The pump works and recirculates into the water tank ok but does not come through when i connect my wand! any ideas ?
can i use a small length of hose open ended to make sure im getting liquid to the hose.
Thanks in advance

[lee_gundry]

yes that will be ok

Lee G

[david knowles]

And if i still get no fluid what are my options  ?

[robert meldrum]

Remove and inspect the jets and clean the filters. Dirt on filters can allow a fair amount of fluid to pass while wet but the dirt can solidify if the wand is not used for a few days

[david knowles]

 I tried the open ended hose and still no jo, so I stripped down the pipes inside the machine it was a pipe that was blocked. all cleaned out now the pressure seemed good but only flowed at a trickle /I timed it at 5 litres in 3 mins is this about right  then 20 minutes to fill 30 litres ?? I have a shurflo 100 psi pump brand new.
thanks

[lee_gundry]

sounds a bit low on the flow??

Lee G

[Kinver_Clean]

Check the pump inlet pipe and filter. Take the filter out and clean it properly, it can look clean but have a clear film over the mesh.

[Jamie Pearson]

might be knackered hose or wand quick connects