[Darren H]

At the moment i have a 27clx pole with standard angle adapter on the end and the pole hose goes up inside the pole but to get the hose out i have to drill hole in the adapter then when i screw the pole to the adapter it nips agaist the hose and the pole often comes loose because you can not tighten fully because you stop the water flow.
Is there a better way to do this or is there something i could  buy to get round the problem.
Thanks for any advice.   

[Griffus]

I have the same pole and adaptor (I think) but no such problem.

Post a picture if possible and I'll compare.

[spudd]

Few lengths of electrical tape round the thread should do the trick 

[Darren H]

[thermoclean]

Buy a new angle adaptor from gardiners has hole in it.

[Darren H]

Ordered a brush from them today and ask them about this im not sure but i think there angle adapters that screw
on which i need on the clx pole. 

[Darren H]

(finish of last post)
the screw angle adapters do not have holes in.   

[Alex Gardiner]

What you need is a Type2 Resi-neck. This simply screws on and allows the pole hose to exit the adapter through a purpose designed hole.

http://www.gardinerpolesystems.co.uk/acatalog/info%5fRESI%5fNECK%5fTYPE2%5fSTD%2ehtml

[Darren H]

Thankyou alex i have a brush i ordered with you late on friday so will be on phone first thing monday morning to add 1 before its
sent.

[Chris Cottrell]

Thankyou alex i have a brush i ordered with you late on friday so will be on phone first thing monday morning to add 1 before its
sent.

Knowing how efficient Gardiners are it's probably already been sent