Thats a good reply from Ross,
Whatever you do do not say that it could have been you, do as Ross did and hand her your gear and ask her to see if she can make a scratch.
Are you talking about a single deep scratch? or a series of scratches?
Is this the sort of scratch caused from something (such as the customers ladder yoiu mentioned) falling against it?
I am always very diplomatic when dealing with customers, and make a point of never arguing with them, when you do you just fuel the arguement.
But when they are accusing you of something such as scratching the windows and not the fact that you may have done a ropey job, then you have to stand very firm.
If you have scratched a window you will know it the moment you have done it, this isn't the type of thing you can do and not notice, lets face it, you can even sense when there is a bit of grit on your applicator, and if something is on the squeegee blade you will notice that immediately anyway.
I have been going over 20 years and I have never scratched the glass so far as I know, I have on occasion been accused of it, but as with Ross's case, it was patently obvious it was the decorators. Prior to window cleaning I ran my own decorating company, I know what I am talking about there! Sandpaper will scratch glass instantly, and it is always a give away when it is on the edges of the glass right by the paintwork.
Don't give a customer the chance to argue, politley explain it simply isn't possible to scratch glass with the equipent you use, offer her your gear for her to try for yourself.
If they keep saying it is your fault then tell them bluntly (still being polite of course
) that it isn't and be unequivocal, give them no room for argument, no if's but's or maybe's. They are welcome to take you to court, there is no way you will claim on your insurance for something you haven't done.
you may be about to lose the customer, that doesn't mattter, stand your ground.
Now it is more than possible to mark the frames, the squeegee will do this over time, paticularly on the type of windows where the panes are held in with beading and not putty, more often than not these are painted with Sadolins, you can have a good size overlap of your squeegee rubber over the end of the squeegee channel, but these are marks you won't stop, fortunately by the time it gets noticable the windows are in need of re-painting anyway
So that really just comes down to wear and tear.
WFP can cause damage to frames too
Usually on old painted windows that have had coat after coat of paint applied over the decades.
The damage?
Chipped paintwork, I lost a job as a result of this, was an old georgian 3 storey town house with large sash windows. It had been converted to an office and they had recently had all the outside redecorated.
I had been cleaning this place for close to 20 years, first names terms with the boss too
Was on the very first clean of this office with the WFP, so I was being extra thorough, lots of washing and rinsing and did each floor twice, windows were gleaming and I was well chuffed with the result
They dried spotless
Ray, the boss, had been away at the time, when I next called back the following month he was away again, but his son said he had gone ballistic, where I had cleaned the bottom sash of each of the higher windows there was a chip mark either side on a corner of the channel that the top sash slides in
Was really noticable too, they were white painted windows and the chip had gone right down to the old dark wood underneath.
They were not big chips, not even as big as my little finger nail, but they showed up, and there were not loads of chips, but there were 2 of them on each window
Fortunately I had been paid the previous month
Told the son to get his dad to ring me and I would come back and make good on the chip marks, he has yet to call
So it was an early lesson learned, the glass is safe of course, but the brush head itself can cause damage, low down it is ok, you have lots of control, but high up the whip in the pole can cause the head to 'clonk' about a bit
And I have noticed the odd chip mark as I have gone along.
New windows, no problem at all, but old ones on old buildings.....TAKE CARE!!
Ian