I need to carry out what I think is a simple repair but would like to check before I do it that it's safe to do so.
I have a secion 2 that is starting to split at the bottom end when I fully extend the section. My plan is to simply remove the section, cut off approx 4 inches at the bottom of the section where is is damaged with a hacksaw, and then re-assemble the pole.
Does anyone know any reason why this wont work in particular cutting thru the carbon fibre with a hacksaw.
Thanks
This will work
Some tips to make this work as smoothly as possible:
1. Wear gloves and a dust mask
2. Carefully mask the section above where you want to cut off
3. Using a sharp hacksaw blade carefully score around the entire circumference first, cutting just a little way in all the way around first (prevents splinters)
4. Continue cutting a little way deeper, all the way round and until gradually you cut through the wall
5. Support the off-cut and cut all the way through making sure the last cut bit is sawn through and does not snap off (prevents splinters)
6. Sand off the newly cut edge
7. Re-apply the overlap tape at the bottom of the section and about 15cm up - about 1.25 wraps is enough - replacing this tape regularly when servicing the pole should stop future damage to the base of the section.