Interested In Advertising? | Contact Us Here
Warning!

 

Welcome to Clean It Up; the UK`s largest cleaning forum with over 34,000 members

 

Please login or register to post and reply to topics.      

 

Forgot your password? Click here

Matt Gibson

  • Posts: 2482
Pressure washer Filtration Question
« on: February 14, 2011, 02:19:30 pm »
Hi guys,

Just a quick one. I have my inlet hose in the top of my tank with a weighted standard filter, but i use a hydrant alot for commercial and have been told i need a finer filter than the standard weighted one i use for when i use the hydrant because of the bits n pieces that are apparently in the hydrant water. is this a myth? or should i invest in a cotton or inline filter for when i use the hydrants?

my thoughts are it would be hard to keep up the flow rate with one of the inline filters..

any thoughts?

Cheers,

Matt

BDCS

  • Posts: 4777
Re: Pressure washer Filtration Question
« Reply #1 on: February 14, 2011, 02:49:28 pm »
Do you not already have a fine filter just before the pump? The one on the suction is a strainer rather rather than a filter and if thats the only one then yes you do need a filter. It can be relatively small in size if you clean it daily, the bigger ones have more capacity which can make cleaning less frequent. Running the suction out the bottom of the tank will also prolong pump life

jaespray

  • Posts: 333
Re: Pressure washer Filtration Question
« Reply #2 on: February 14, 2011, 02:53:17 pm »
hi matt   i have in my feed bowser two brass/stainless steel 50micron (i think) filters  fitted to "T" piece that jions my feed pipe   i have no problems drawing 30lts a min   make shure all your fitting are brass or stainless steel  make shure you hydrant unit is stainless or aly     when opening the hydrant i think its 4inches    just let it blow for a few second to clear any debris then you should have few problems     ps a frog forced from a 4inch pipe into a 1inch pipe make a hell of a mess
regard john

Matt Gibson

  • Posts: 2482
Re: Pressure washer Filtration Question
« Reply #3 on: February 14, 2011, 03:00:02 pm »
cheers for the replies guys, any chance of a few links to some of the filters your talking about?


BDCS

  • Posts: 4777

jaespray

  • Posts: 333
Re: Pressure washer Filtration Question
« Reply #6 on: February 14, 2011, 03:59:53 pm »
hi matt   or try wwwdualpumps.co.uk . fittings and filters
regards john

Blast Off Stoke

  • Posts: 119
Re: Pressure washer Filtration Question
« Reply #7 on: February 14, 2011, 06:46:10 pm »
Does your washer not have two filters on anyway.
One on the feeder pipe that goes into the tank and one on the brass inlet on your machine ?

Blast Off Stoke

  • Posts: 119
Re: Pressure washer Filtration Question
« Reply #8 on: February 14, 2011, 06:47:45 pm »
sorry BDCS im just repeating what you said.
I should pay more attention next time  ::)

Blast Away

Re: Pressure washer Filtration Question
« Reply #9 on: February 16, 2011, 08:59:48 pm »
 ;D ;D ;D ;D

I had a frog once when blowing through the poope.

Matt Gibson

  • Posts: 2482
Re: Pressure washer Filtration Question
« Reply #10 on: February 16, 2011, 09:18:47 pm »
Ribbitt