Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: gwrightson on March 04, 2009, 07:42:22 am

Title: sheen on floor
Post by: gwrightson on March 04, 2009, 07:42:22 am

can you stone experts advise me on the best possible sealer to apply to a stone floor, the custy is not sure sure what type of stone it is , but i,m going along today to take a look ,"will take some pics "  she wants it to have a high sheen finish that wont keep wearing out , " her words " she says she uses lithonium at the moment 1 coat only and after 3 or 4 weeks it goes dull and loses it colour. she isnt to bothered about expense of the sealer providing it will last.
So basicly I need a little info as what I should recommend.
Geoff
Title: Re: sheen on floor
Post by: gwrightson on March 04, 2009, 06:53:40 pm
lots of experts in this section then  :'( 

Geoff
Title: Re: sheen on floor
Post by: sherco on March 04, 2009, 07:11:50 pm
The one i would use is Aquamix floor shine & hardener, you will need to strip old sealer of the stone using there sealer & coatings remover. You will need a floor scrubbing machine and a wet vac to remove the cleaner from the floor, then wash it with just water to remove any of the cleaner, then leave the floor for a day to dry, then seal following the instructions. If you need any moreinfo let me know. ;D ;
Title: Re: sheen on floor
Post by: gwrightson on March 04, 2009, 08:07:05 pm
tks sherco,

where can i purchase this Aqua mix ?

Does it give a high sheen ?  this is idealy what she is wanting.

I shall be cleaning using a pressure spinner with vac attached, after applying the stripper.

geoff
Title: Re: sheen on floor
Post by: sherco on March 04, 2009, 10:07:44 pm
Try www.tradetiler.co.uk, its not on the web site so you will have to call him.
Title: Re: sheen on floor
Post by: Chris B on March 05, 2009, 07:48:59 am
Make sure you get the floor as neutral as possible for the seal to take to.
Title: Re: sheen on floor
Post by: expro on March 05, 2009, 08:20:57 am
Is the customer expecting too much?.No seals last forever.Good point about neutralising with an acidic rinse prior to applying the seal.