Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: rb4no on June 24, 2024, 06:53:09 pm

Title: fsc help
Post by: rb4no on June 24, 2024, 06:53:09 pm

hi guys, recently refurbished my fsc with new bearings and out everything back how it was dismantled. Thing is that it didn't spin as freely as before and actually stopped whilst I working with it? I've since dismantled it and can't see a problem. The fsc is fro jetmac but the spinney bit looks very generic and looks like many others out there.  Any thoughts?

Title: Re: fsc help
Post by: Smudger on June 25, 2024, 11:09:04 pm

What bearing did you get - cheap bearing can cause issues as in size and tolerances

Did you grease it well and use the correct spec ?

Title: Re: fsc help
Post by: rb4no on July 01, 2024, 12:59:01 pm

Yes went to a bearing specialist in Norwich and got like for like.

Title: Re: fsc help
Post by: Smudger on July 01, 2024, 04:09:27 pm

Norwich !

oh dear  :(

they only deal with trac-tors boy!

Title: Re: fsc help
Post by: Smudger on July 01, 2024, 04:11:27 pm

when you dismantled it did the bearing run free at this point ?

Title: Re: fsc help
Post by: rb4no on July 03, 2024, 04:02:37 pm

the first time I dismantled it the bearings were on there way out so got those replaced, been scratching around trying to figure whats' going on to no avail so bit the bullet and bought a new internal shaft section, I'll compare the two side by side to see what's wrong with the original  and then use it for spares I guess...

Title: Re: fsc help
Post by: Smudger on July 03, 2024, 11:15:01 pm

so you haven't dismantled it since putting in the new bearings ?

if so, have you checked they still spin freely ?